Ovulation test (strips)

Home / Testera tests / Ovulation test (strip)

Ovulation test (strip)

The test is used to diagnose ovulation, to detect elevated levels of LH in urine.

The rapid LH ovulation (urine) test detects an increase in LH in the urine, indicating that ovulation is likely to occur within the next 24-36 hours.

Determine the day you will start testing according to the table "When to start testing" For this test you need
use a timer (not supplied).

Wait for the test and urine sample to cool to room temperature before performing the test
(15-30 °C).
Keep the bag at room temperature before opening it. Remove the liquid level gauge from the
in a sealed bag and use it within one hour.
With the pointers pointing at the urine sample, vertically immerse the test fluid level meter in
urine sample for at least 10-15 seconds. Do not dip the dipstick deeper than the MAX line. See below
see illustration below.
Place the test liquid level meter on a clean, dry, non-absorbent and flat surface and
start the timer.
Wait for the coloured line(s) to appear. Check the results after 5 minutes. After 10
do not check the results again. The used test can be disposed of with household waste.

Positive	Two lines are visible and the line in the test line area (T) is the same as or darker than the line in the control line area (C). This means that ovulation is likely to start within the next 24-36 hours.
Negative	Two lines are visible, but the line in the test line area (T) is lighter than the line in the control line area (C) or there is no line at all in the test line area (T). This means that no increase in hLH is detected.
Not valid	The control line does not appear. The most likely reasons for the non-appearance of the reference line are insufficient sample quantity or an incorrect procedure. Revise the procedure and repeat the test with a new test. If the problem persists, stop using the test kit and contact your local distributor.

Instruction leaflet

You can buy this test: